Platform 1 Model Railway Community Home 


Welcome to Platform1mrc.com
Thank you for taking the time to browse the forum, if you would like to participate in any of the discussions.
Registration is only a click away Register Here.

 Moderated by: Toto
New Topic Reply Printer Friendly
o gauge progress
AuthorPost
 Posted: 15 Nov 2017 11:14
  PM Quote Reply
1st Post
RALPH
Member


Joined: 25 Mar 2016
Location: Armadale Western Australia, Australia
Posts: 154
Status: 
Offline
Retaining wall using 6mm Ply and 5mm Ply. First I have lots of 00 Scalescenes  Brick, buildings, etc etc that I've had for quite a while. SO firstly selected TX_24 00 Brown brick, then used 175% to bring it upto'0' Scale and printed out A4 sheets on (Double sided Matte 250 GSM Photo paper) for wall, then printed out two more on ordinary copy paper for abutments and ease of folding.
The colour turned out better for me these colours Below


Wall 6mm Ply,  Abutments 5mm ply






Capping stones 00 scale Metcalfe Pavers they worked out just right (for my wall tops):thumbs: 


walls will go at back from left corner to rear of engine shed, :scratchchin:
which is 2.3 meters in length, http://www.clickRALPH




____________________
If you want it, like it, go for it, as you only come this way once, it's not a trial run !!!
Back To Top PM Quote Reply  

Current time is 16:03  
This topic is:  Home Page > Platform 1 Model Railway Community > The Learning Zone > Workshop Benches > o gauge progress Top





about cookie files used by this web site

UltraBB 1.172 Copyright © 2007-2016 Data 1 Systems