It is easy to put videos on YouTube, costs nothing, I just download them from my phone and if I can do it anybody can. :thumbup:
I’ve not seen lamp irons like that before or perhaps I haven’t noticed them. Multipurpose irons, forward thinking by the GWR again. Ducks behind...
I’m getting this on Safari.
When I worked for the GPO Telephones all screws had to have their slots vertical.
Join the club Mossy. :facepalm:
Same as the crank shaft on a car engine I guess. The axle doesn’t go straight through it is divided into 5 sections with two of them offset where...
I always used 0.45mm diameter wire on my OO diesels. Just held it in some pliers and folded it over with my specialist tool, a finger.
Heat shrink tube in generally shiny so why not remove the shine first with some fine emery paper or similar for better traction.
One problem with lubricating non metal gears is that any dust/dirt that sticks to the lubricant may wear out the gear.
'O' rings have a round cross section so would be unsuitable, the tyres need to be flat.
Can’t see why, it deserves to be on the front page, great work.
How unusual, brilliant.
You must have eyes like an owl ️️
Same here 16 years.
I’ve seen those. Think Rob's does that.
Are you referring to the Mossy version. If the handle is turned 90 degrees with the hand hold on the outside there is a slot in the lid to go over...
I retired in 2006 age 57. I’ve loved every second of it. Hard work though.
The man from Echuca is going to have a lot of fun with that.
Whether they use oil or water surely it leaves an oily/damp film on everything, not ideal for electric motors.