DCC Loco Conversions - 60 - Mainline Class 45 1976

Discussion in 'DCC Control' started by Jim Freight, Mar 25, 2025.

  1. Jim Freight

    Jim Freight Full Member

    Messages:
    2,257
    Likes Received:
    1,941
    Joined:
    Sep 9, 2019
    I have two of these, D49 bought new when first released in 1976, D100 bought second hand in 2017, a later version with headcode lights.

    This conversion assumes that the loco is in good running order, many Mainline locos are not even if they have had little use since new.

    D49 with good tyres has enough grip to haul 6 re-wheeled Mainline brand coaches up a 1:48, including a standing start, D100 lighter needed additional weight.

    Outlne of Work Required

    These locos especially D49 are about as easy as it gets, power pickup from the unpowered bogie travel the length of the loco to the motor in the other bogie, plenty of space and simple wiring.

    A litte more wiring in D100 as it has headcode lighting with small filament lamps.

    D100 also needs more ballast as the nose weights were removed to make space for the cab interior and headcode lamp.

    Decoder Fitting - D49

    Connections to motor were bad, poor blobby soldering, corroded wires, down to a strand or two, as below.

    1 DSCF3561.JPG

    Wires cut back and re-soldered.

    Wires from pickups cut near to where the decoder is mounted, for this loco a Lenz 10231-01 Standard+ is inserted and stuck down with supplied sticky pad.

    2 DSCF3568.JPG

    3 DSCF3566.JPG

    4 SCF3571.JPG


    Job done.

    Decoder Fitting - D100

    Wires from pickups cut near to where the decoder is mounted, for this loco a Lenz 10231-01 Standard+ is inserted and stuck down with supplied sticky pad.

    This decoder is capable of driving these small filament lamps directly, beware not all decoders can.

    1. Blue wire to both lamps
    2. White wire to front lamp
    3. Yellow wire to rear lamp

    In use, selecting F0 and direction will light up the headcode according to the direction of travel.

    Fitted extra ballast as an arch of lead insulated on the inside with Duck tape (as a precaution) and notched to allow headcode light wires to access the cab area.

    The large unused crimp connectors can be removed to gain extra height clearance between the top of the motor and the lead arch.

    Screws holding the motor connections were loose so needed tightening, carefully as they screw into plastic.

    5 DSCF3577.JPG

    6 DSCF3573.JPG

    7 DSCF3579.JPG

    Job done.

    Summary

    Note,that I wired these with forward being what I now know is the reverse for diesel locomotives, i.e. fan at the rear, not changing my fleet of diesels now, consistency is better even if it is wrong :avatar:

    D49, a very simple conversion.

    D100, short on weight, easily added, and the motor terminal screws can be loose, it may be better to remove the unused crimp tags to which the wires are soldered to and instead solder the wires directly to the brush retainers as on other Mainline conversions.

    Lighting with an appropriate decoder is straightforward, others may need LEDs and resistor substituted.

    As an example see "DCC Loco Conversions - 48 - Jouef Class 40 1977".

    I have found these to be solid, smooth running and reliable, probably the best of my Mainlne locos.


    Discussion always :welcome:

    Jim :)

    Return to Index
     
    Last edited: Mar 25, 2025
    Ron likes this.

Share This Page