Mashima motor 1633 and Slaters SG38 gearbox

Discussion in 'Power Houses' started by Toto, Apr 28, 2020.

  1. Toto

    Toto I'm best ignored Staff Member Founder Administrator

    Messages:
    14,176
    Likes Received:
    2,708
    Joined:
    Dec 5, 2017
    This is a teeny weeny motor and gearbox. Aimed I think at the OO scale models .... but this one has a 3 / 16 axle bearing so suitable for small O Gauge locks. The gearbox is a 38:1 ratio.

    I have just taken delivery of two from slaters. These will be used on my Ramsbottom 0-4-0 four foot shunter and my Ramsbottom 0-4-2 crane shunter. Both Gladiator kits.

    Pictures will be posted later along side a normally used Mashima 1833 motor to give a sense of scale.

    Cheers for now

    Toto
     
  2. Toto

    Toto I'm best ignored Staff Member Founder Administrator

    Messages:
    14,176
    Likes Received:
    2,708
    Joined:
    Dec 5, 2017
    And here we are ..... the piccies as promised


    as it comes .....


    out the packet with the axle gear ....

    and a comparison with the larger Mashima motor .....


    quite some difference ....... Now .... just to fit it ....

    cheers for now.

    toto
     
    paul_l and jakesdad13 like this.
  3. paul_l

    paul_l Staff Member Administrator

    Messages:
    6,889
    Likes Received:
    2,136
    Joined:
    Dec 5, 2015
    Just dont unscrew the terminal screws or they ping off ..... too late

    Paul
     
  4. Toto

    Toto I'm best ignored Staff Member Founder Administrator

    Messages:
    14,176
    Likes Received:
    2,708
    Joined:
    Dec 5, 2017
    Yes,

    I'm now minus a horrifically small but critical spring. I will need to try and get a replacement ....... only had it for a day. :facepalm: £ 75.00 down the drain. Well the motor at least unless I can come up with a spring. A phone call to Slaters maybe ?

    Toto
     

Share This Page