Swapping TTS fitted non powered HST power cars between sets

Discussion in 'DCC Sound' started by Tallpaul70, Dec 6, 2019.

  1. Tallpaul70

    Tallpaul70 Full Member

    Messages:
    205
    Likes Received:
    95
    Joined:
    Mar 2, 2019
    Hi All,
    Sorry if this question has already been discussed, but I couldn't find it!

    I have several of the latest version of the Hornby HSTs fitted with TTS chip pairs.

    How do I set up on my NCE controller to run the powered class 43 from one set with the unpowered class 43 from another. These are set up as different code numbers, but only one will be responding to power commands, the other just to sound and light commands.
    Do I set them up as a consist?

    Many thanks
    Paul
     
  2. Andy_Sollis

    Andy_Sollis Staff Member Moderator

    Messages:
    3,894
    Likes Received:
    3,621
    Joined:
    Aug 4, 2018
    I would suspect you place a powered and dummy on your program track at the same time, set your new CV1 address then do the same for the next pair?

    Et Voila, two sets of HST’s...
     

Share This Page